Intermec PX4i PX4i and PX6i High Performance Printer User's Manual - Page 79
To con the printer to use WPA or WPA2 Enterprise mode, Connecting the Printer - login
View all Intermec PX4i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 79 highlights
Chapter 2 - Connecting the Printer 2 Send one of the following WPA/WPA2 ON commands to turn on WPA or WPA2 authentication. Send the WPA-PSK or WPA2-PSK command to set a pre-shared key: setup "wlan","WPA","OFF" setup "wlan","WPA2","ON" setup "wlan","WPA_PSK","xxxxxxxxxx" setup "wlan","ACTIVE","1" setup write "wlan","uart1:" where xxxxxxxxxx is a value between 8 and 64 characters. To configure the printer to use WPA or WPA2 Enterprise mode 1 Send the following commands to login as an admin and set the SSID: run"su-p pass admin" setup write "wlan","uart1:" setup "wlan","SSID","xxxxx" where xxxxx can be from 0 to 32 alphanumeric characters. To enter non-alphanumeric octets, use "%nn," where nn is two hexadecimal digits representing the value of the character Note: The default password for logging in as an admin is "pass." If you have changed the password, you will need to use your password instead of "pass." 2 Send one of the following WPA/WPA2 ON commands to set up WPA-802.1x or WPA2-802.1x authentication. You should also send the WPA_PSK command that does not contain a value: setup "wlan","WPA","OFF" setup "wlan","WPA2","ON" setup "wlan","WPA_PSK","" setup write "wlan","uart1:" To view the 802.1x values, send this command: setup write "8021x","uart1:" PX4i and PX6i High Performance Printer User's Manual 65