Kyocera KM-2540 Fax System (P) Operation Guide Rev-1 - Page 104

Register box Subaddress relay box 3333. 0715. 8888. Register box Subaddress relay box01. Password confirmation Enter password using # key. _. ( 4 digits) If you selected to send a Transmission Report to the initial transmitting station, go to the next step. If you selected NOT to send a report, proceed directly to step 14. 12 Enter the fax number of the initial transmitting station. Note You can use the numeric keys, one-touch keys and Chain dial keys to enter the fax number. 13 Press the [Finish dest. Set] ([Dest. set]) key. 14 Check the registered information. Each item can be modified. 15 Press the [OK] key. The message display will return to the same screen as was displayed in step 4. If you want to continue registering other F-Code Relay Boxes, repeat steps 4 through 15. Once you are finished registering F-Code Relay Boxes, press the Reset key. Modifying or Deleting F-Code Relay Boxes Perform the following procedure when you want to add or delete final destinations or change other information registered under any F-Code Relay Box, as well as when you want to completely delete one of those boxes. Note In order to modify the contents of or completely delete an FCode Relay Box, it is necessary to enter the corresponding FCode password during the procedure. If you want to cancel the procedure part way through, press the Reset key. The touch panel will return to the initial mode settings. 1 Perform steps 1 through 3 of Registering New F-Code Relay Boxes on page 3-42. 2 Press the key which displays the subaddress for the F-Code Relay Box you want to modify or delete. 3 Enter the F-Code password (4-digits) for that F-Code Relay Box. 4 Press the [Confirm] key. Ba 3-44 Fax Operation (Advanced)