Kyocera KM-2540 Fax System (P) Operation Guide Rev-1 - Page 200

CODE U01821 U02200 U02400 U03000 U03200 U03300 U03400 U03500 U03600 U03700 U04000 U04100 U04200 U04300 U04400 8-12 CAUSE AND/OR PROCEDURE FOR CORRECTION A communication error occurred during reception at high transmission speed. Your unit may not have the corresponding high speed reception capabilities. Perform reception procedures again after having the transmitting party lower the transmission speed. An F-Code Based Relay Broadcast Transmission command was received, but transmission to the remaining final destination(s) was impossible because the destination FAX phone number(s) that was(were) registered for the corresponding F-Code Relay Box in your FAX machine has(have) been deleted. Check the information registered in your FAX and have the initial transmitting station perform the transmission operation again. An F-Code Based Relay Broadcast Transmission command was received, but was unsuccessful because the F-Code Relay Box ID that the initial transmitting station entered did not match the one registered in your FAX. Check the information registered in your FAX and have the initial transmitting station perform the transmission operation again. Polling Reception was attempted, but was unsuccessful because no documents had been placed in advance in the transmitting party's FAX. Check with the transmitting party. The transmitting party's FAX is one of our models and an F-Code Based Bulletin Board Reception was attempted in order to receive documents from that party's F-Code Box, but was unsuccessful because there were no documents stored in the corresponding F-Code Box. An error has occurred due to one of the following reasons. Check with the other party. (1) A Polling Reception was attempted in order to receive documents from the other party's FAX, but was unsuccessful because TX/RX Restriction was turned ON in the other party's FAX and the necessary password did not match. (2) The transmitting party's FAX is one of our models and an F-Code Based Bulletin Board Reception was attempted in order to receive documents from that party's F-Code Box, but was unsuccessful because TX/RX Restriction was turned ON in the other party's FAX and the necessary password did not match. Polling Reception was attempted, but was unsuccessful because the password input in the transmitting party's FAX and the self-station ID of the receiving party did not match. Check with the other party. The transmitting party's FAX is one of our models and an F-Code Based Bulletin Board Reception was attempted in order to receive documents from that party's F-Code Box, but was unsuccessful because the F-Code Box number that you entered was not registered in the other party's FAX. The transmitting party's FAX is one of our models and an F-Code Based Bulletin Board Reception was attempted in order to receive documents from that party's F-Code Box, but was unsuccessful because the F-Code password that you entered did not match the one registered in the transmitting party's FAX. An F-Code Based Bulletin Board Reception was attempted in order to receive documents from the other party, but was unsuccessful because the other party's FAX does not have FCode Based Bulletin Board Transmission capabilities or because there were no documents stored in the corresponding box. The destination FAX is one of our models and an F-Code Based Confidential Transmission was attempted in order to transmit documents to that party's F-Code Box, but was unsuccessful because the F-Code Box number that you entered was not registered in the destination party's FAX. A transmission to a destination party's box (ex. F-Code Box) was attempted, but was unsuccessful because the destination party's FAX does not have F-Code Based Confidential Reception capabilities. Encryption Transmission was attempted, but was unsuccessful because the Encryption Box was not registered in the other party's FAX. Encryption Transmission was attempted, but was unsuccessful because the other party's FAX does not possess Encryption Communication capabilities. Encryption Transmission was attempted, but was unsuccessful because the Encryption Keys did not match. Reference Information