Lexmark OptraImage Color 1200r User's Guide - Page 44
Setup Menu continued, Wait Timeout
View all Lexmark OptraImage Color 1200r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
Setup Menu (continued) Menu item Download Target Values RAM* Flash Disk Print Timeout The Download Target menu item specifies where you want to store downloaded resources. Storing downloaded resources in flash memory or an optional hard disk is permanent storage rather than the temporary storage that RAM provides. You can add resources to flash memory or disk until the device is full. Use your software application or the MarkVision printer utility to download resources to the printer. The Download Target menu item is only displayed if the flash memory or hard disk is not defective or Read/Write or Write protected. Disk is not an available value for Download Target if Job Buffer Size is set to 100%. Disabled 1...255 (90*) Wait Timeout The Print Timeout setting determines the time (from 1 to 255 seconds) the printer waits before printing the last page of a print job that does not end with a command to print the page. The print timeout counter does not start until the printer displays the Waiting message. When a print timeout occurs, the printer stores the page in the print buffer. When Print Timeout is disabled, the printer does not print the last page of a print job until one of the following occurs: • The printer receives enough information to fill the page. • The printer receives a Form Feed command. • You select Print Buffer from the Job Menu. See page 28 for more information. Disabled 15...65535 (40*) *Factory default The Wait Timeout setting determines the amount of time in seconds the printer waits to receive additional bytes of PostScript data from the computer. When this timeout expires, the print job is canceled. Select Disabled to turn Wait Timeout off. The Wait Timeout menu item is only available when using PostScript Level 2 emulation. The setting has no effect on PCL emulation print jobs. 30 Chapter 2: Changing printer settings