Yamaha DM1000 Owner's Manual - Page 111

Input & Output Patching Patching Direct Outs 111 Patching Direct Outs Input Channel 1-48 signals can be directly patched to any outputs or slot outputs, as well as Bus Out 1-8 and Stereo Out. This patching is convenient when you wish to record each Input Channel signal to an individual track on a connected recorder. 1 Press the DISPLAY ACCESS [OUTPUT PATCH] button repeatedly until the Out Patch | Direct Out page appears. 1 2 9 The parameters on this page are described below. A 1-48 These boxes indicate the Direct Out destination (outputs and slot channels) for Input Channels 1-48. B DIRECT OUT Determines the Direct Out signal source position from the following three options: • PRE EQ Immediately before Input Channel EQ • PRE FADER Immediately before Input Channel fader • POST FADER Immediately after Input Channel fader 2 Move the cursor to a patch parameter (1-48) you wish to change, and rotate the Parameter wheel or press the [INC]/[DEC] buttons to select the destination. If necessary, specify the signal source position using the DIRECT OUT parameter. 3 Press [ENTER] to confirm the change. Note: If you select a destination that has already been used for an output patch, the patch parameter box indicates "- (no assignment)." If you assign the Direct Out to an unused destination, the parameter box indicates the corresponding output. 4 Press the [SEL] button or move the fader of the Input Channel that is patched to the Direct Out assigned in Steps 2 and 3. 5 Press the SELECTED CHANNEL ROUTING [DIRECT] button. The Direct Out patching is now effective, and the signals are routed to the assigned outputs or slot channels. Tip: Press the SELECTED CHANNEL ROUTING [DISPLAY] button repeatedly to display the Routing page. On this page, you can simultaneously route multiple Input Channels to Direct Outs. DM1000-Owner's Manual