Yamaha DM1000 Owner's Manual - Page 131
Surround Monitoring
View all Yamaha DM1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 131 highlights
Surround Monitoring 131 A Surround pan graphs These graphs display the trajectory patterns and the current pan positions for the Input Channels. Move the cursor to the desired channel's graph, then rotate the Parameter wheel to adjust the pan settings along the selected trajectory pattern. Turning on the [GRAB] button enables you to use the Joystick to set the surround pan of the currently-selected Input Channel. Press [ENTER] while the cursor is on the graph to display the Ch Edit page for the selected channel. B parameter box This parameter box enables you to move the surround pan setting of the selected channel left and right. C parameter box This parameter box enables you to move the surround pan setting of the selected channel front and rear. Surround Monitoring About Surround Monitoring The DM1000 features comprehensive surround monitoring functions that enable you to monitor, in the optimum environment, the surround sources in the Buses or those input from Slot 1 or 2. These functions include down mixing (which enables you to monitor signals on fewer channels) and fine-tuning of surround channel signals according to the monitoring environment. The surround monitoring functions also feature an oscillator for testing speakers, a monitoring matrix for down mixing, Bass Management for optimizing channel signals for the monitoring environment, and monitor alignment using individual Attenuator and Delay parameters for each speaker. 8x8 SLOT1 1-8 8 Patch 8 SLOT SLOT2 1-8 8 8 BUS1-8 8 BUS STEREO 2 PINK NOISE 500-2kHz BPF 1kHz, 50Hz 8 MONITOR MATRIX FROM CONTROL ROOM L/R TO CONTROL ROOM DIMM C-R to SURROUND MONITOR MONITOR LEVEL SURROUND MONITOR BASS MANAGEMENT MONITOR ALLIGNMENT TO OUTPUT PATCH DIMM Surround Functions 11 MONITOR MATRIX OUT To monitor the Surround Monitor signal via the surround system, you must connect the system to the output connectors on the DM1000, then patch the Surround Monitor signal source to these connectors. For example, if the surround system is connected to the OMNI OUT connector, press the [OUTPUT PATCH] button repeatedly until the Out Patch | OMNI Out page appears. This page will enable you to patch the surround channel (indicated as "SURR XXX" where "XXX" is the channel name) to the corresponding OMNI OUT connector. DM1000-Owner's Manual