Yamaha DM1000 Owner's Manual - Page 150
Inserting the Internal Effects into Channels, Ins/Dly | Insert appears.
View all Yamaha DM1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 150 highlights
150 Chapter 13-Internal Effects Inserting the Internal Effects into Channels You can insert the internal effects into certain Input Channels or Output Channels (Bus Outs 1-8, Aux Outs 1-8, Stereo Out). Note: If effects are inserted in channels, you cannot use those effects via Aux Sends or insert them into other channels. 1 Select an internal Effects processor (1-4), then recall the desired effect programs. 2 Press the [SEL] button or move the fader of the Input Channel or Output Channel into which you want to insert the selected effects. Tip: Repeatedly pressing the STEREO [SEL] button toggles between the left and right Stereo Out channels. 3 Press the DISPLAY ACCESS [ /INSERT/DELAY] button repeatedly until the /Ins/Dly | Insert page appears. 4 Select the effect insertion position using the INSERT button in the POSITION section. 5 Move the cursor to the OUT parameter box in the INSERT section, then select the inputs of the effects processor selected in Step 1. • FX1-1 through FX1-8 . Inputs 1-8 of Internal Effects Processor 1 • FX2-1 & FX2-2 Inputs 1 & 2 of Internal Effects Processor 2 • FX3-1 & FX3-2 Inputs 1 & 2 of Internal Effects Processor 3 • FX4-1 & FX4-2 Inputs 1 & 2 of Internal Effects Processor 4 6 Press [ENTER] to confirm the setting. 7 Move the cursor to the IN parameter box in the INSERT section, select the outputs of the effects processor selected in Step 5 and 6, then press [ENTER] to confirm the setting. 8 Move the cursor to the ON/OFF button in the INSERT section, then press [ENTER] to turn on the button. Effect insertion is now enabled. Tip: • After inserting effects to channels, adjust the MIX BALANCE parameter for the effects, according to the purpose and effects type. • Move the cursor to an empty IN or OUT parameter box and press the [ENTER] button. The Patch Select window appears, which enables you to quickly select available signal paths. DM1000-Owner's Manual