Yamaha DM1000 Owner's Manual - Page 184
Recording an Automix, Creating a New Automix
View all Yamaha DM1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 184 highlights
184 Chapter 16-Automix Recording an Automix This section describes a general procedure for Automix recording, including creating a new Automix, as well as recording the fader, [ON] button, and other controller events real-time. Creating a New Automix Follow the steps below to create a new Automix and select the parameters you want to record. 1 Connect a timecode source to the DM1000. 2 Select the timecode source on the Setup | Time Ref page (see page 182). If you selected MIDI CLOCK timecode, create a time signature map (see page 183). 3 Press the DISPLAY ACCESS [AUTOMIX] button repeatedly until the Automix | Main page appears. This page enables you to set the basic Automix parameters, and record and play back Automixes. 4 Move the cursor to the NEW button located in the lower-right corner of the page, then press [ENTER]. A confirmation window for creating a new Automix appears. 5 Move the cursor to the YES button, then press [ENTER]. A new Automix is created. 6 Move the cursor to the AUTOMIX DISABLED/ENABLED button, then press [ENTER] to switch it to ENABLED. The new Automix is enabled. 7 In the OVERWRITE section, select parameters you want to record. The seven buttons in the OVERWRITE section enable you to select parameters to be recorded in the Automix, including the following. See page 187 for more information. • FADER Fader operation • ON ON] button on/off DM1000-Owner's Manual