Yamaha DM1000 Owner's Manual - Page 59

Input Channels 59 6 Input Channels This chapter describes how to adjust the DM1000's Input Channel parameters. About Input Channels The input Channel section enables you to adjust the level and tone of the signals input to the DM1000 and route the signals to Bus 1-8, Stereo Bus, and Aux Out 1-8. The following diagram illustrates the Input Channel signal flow. INPUT PATCH BUS1 BUS2 BUS3 BUS4 BUS5 BUS6 BUS7 BUS8 STEREO L STEREO R SOLO L SOLO R AUX 1 AUX 8 INPUT 1(...48) (Gain Reduction) METER (Out Meter) METER GATE ATT Keyin 12ch Group(1-12,13-24....) AUX 1-8 METER INSERT 4BAND EQ INPUT DELAY METER SOLO INSERT ON LEVEL PAN PAN (Gain Reduction) (Out Meter) METER METER COMP LFE PRE/POST ON AUX Keyin Self or Stereo Link DIRECT OUT 1(...48) Input Channels 6 • (Phase) This section switches the phase of input signals. • GATE This dynamics processor can be used as a gate or for ducking. • COMP (Compressor) This dynamics processor can be used as compressor, expander or limiter. The compressor can be pre-EQ, pre-fader, or post-fader. • ATT (Attenuator) This section enables you to attenuate or amplify the level of signals that will be input to the EQ. The attenuator enables you to prevent post-EQ signals from clipping and to correct signal levels that are too low. • 4 BAND EQ (4-band equalizer) This parametric EQ features four bands (high, high-mid, low-mid, and low). • INPUT DELAY (Input delay) This section enables you to delay input signals. You can use this delay to fine-tune the timing between channels, or as a delay effect with feedback. • ON (On/Off) This section enables you to turn the channel on or off. The channel is muted with the Off setting. • LEVEL This section enables you to adjust the input level of the Input Channel signal. DM1000-Owner's Manual