Yamaha DM1000 Owner's Manual - Page 115

Control Room Monitoring 115 10 Control Room Monitoring This chapter explains how to set up control room monitoring and use the Solo and Talkback functions on the DM1000. Control Room Monitor The DM1000 features the Control Room stereo signal path to feed the control room's main monitors. By default, the Control Room signal source is patched to OMNI OUT connectors 11 & 12, which can feed the Control Room signal to the control room's monitor. SOLO L SOLO R MONO DIMM SOLO L SOLO R SOLO TRIM BUS1-8 AUX1-8 OUTPUT SOLO 8 8 STEREO 2TR D1 OMNI IN1/2 2TR D2 OMNI IN3/4 MONITOR SELECT 2 2 2 SOLO LOGIC METER MONITOR LEVEL PHONES DA LEVEL DA [PHONES] CONTROL ROOM • MONITOR SELECT As a Control Room Monitor signal, you can select one from Stereo Out output, 2TR IN DIGITAL 1 input, and 2TR IN DIGITAL 2 input. If you change the parameter setting on the Monitor | Solo/C-R page (see page 116), you can monitor the OMNI IN signal, instead of the 2TR IN DIGITAL signal, when you press the [2TR D1] or [2TR D2] button. • SOLO bus This special bus routes soloed Input Channels to the Control Room Monitor output, bypassing Bus 1-8 and the Stereo Bus. • OUTPUT SOLO This section routes soloed Output Channels (Aux Out 1-8, Bus Out 1-8) to the Control Room Monitor output. Note: Input and Output Channels cannot be solo-monitored simultaneously. The solo function for the most-recently soloed channels is enabled. • MONITOR LEVEL Use the MONITOR [MONITOR LEVEL] control on the top panel to adjust the Control Room Monitor level. • DIMM (Dimmer) The [DIMMER] button lowers the Control Room Monitor signal by the specified amount. Note: The Dimmer function is activated automatically when the Talkback or Oscillator function is active. • PHONES The Control Room Monitor signal is also fed to the PHONES jack. You can set the level independently. Control Room Monitoring 10 DM1000-Owner's Manual