Yamaha DM1000 Owner's Manual - Page 125
Press the DISPLAY ACCESS [OUT PATCH] button repeatedly until the Out, To change the assignment
View all Yamaha DM1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 125 highlights
Using Surround Pan 125 6 To change the Surround Channel to Bus Out assignment, move the cursor to the SURR/BUS SETUP button, then press [ENTER]. The Setup | Surr Bus page appears. 2 1 A BUS1-BUS8 These parameters select channels to be assigned to the Bus Outs in 3-1, 5.1, and 6.1 Surround modes. B INIT These buttons reset the channel assignment to the default setting. 7 To change the assignment, move the cursor to the desired Bus parameter, rotate the Parameter wheel to select a channel, then press [ENTER]. The channels are swapped between the selected Bus and the Bus to which the channel assigned to the selected Bus was assigned previously. Tip: • Pressing the DISPLAY ACCESS [SETUP] button repeatedly also displays the Surr Bus page. • Available Bus Outs vary depending on the Surround mode. For example, in 3-1 Surround mode, Bus Outs 1-4 are available. In 5.1 Surround mode, Bus Outs 1-6 are available, and in 6.1 Surround mode, Bus Outs 1-7 are available. 8 Press the DISPLAY ACCESS [OUT PATCH] button repeatedly until the Out Patch | Slot Out page appears, then make sure that each Bus Out is routed to the desired channel on the digital I/O card. To monitor signals routed to the digital I/O card in the surround environment, use surround monitoring (see page 131). Surround Functions 11 DM1000-Owner's Manual