Yamaha DM1000 Owner's Manual - Page 143

Using Fader Groups and Mute Groups 143 2 Press the up ( ) or down ( ) button to select a group. Example: Fader group C is selected. 3 Press the [SEL] button for a channel you wish to add to the group. The selected channel is marked with " " and the channel is added to the group. Example: Input Channels 1-6, and 13-14 have been added to Fader group C. Tip: • If you add one channel from a pair to a group, the pair partner is automatically added to the group. • You can also select a channel on another layer by switching layers. 4 In the same way, press the [SEL] button for other channels you wish to add to the group. The relative level of the faders for the grouped channels is determined by the position of the faders when the channels were added to the group. The On/Off status of the grouped channels is determined by the [ON] button status when the channels were added to the group. 5 To turn a group on or off, move the corresponding button in the ENABLE column, then press [ENTER]. When the group Enable button is turned off, the corresponding group is temporarily cancelled. 6 To use a fader group, operate one of the faders for the grouped channels. Note: • If you wish to change the relative level balance between the grouped channels while this page is displayed, first turn off the Enable button or remove the channels for which you want to change the level from the group. • If other pages are displayed, press and hold down the [SEL] button for the desired channels to temporarily remove them from the group, then change the level balance. Grouping Channels & Linking Parameters 12 DM1000-Owner's Manual