Yamaha DM1000 Owner's Manual - Page 48

48 Chapter 4-Connections and Setup • 2D2L & 2D2R 2TR DIGITAL IN 2 (L/R) • BUS1-8 Bus 1-8 Outputs • AUX1-8 Aux Send 1-8 Outputs 2 Use the cursor buttons to move the cursor to a patch parameter (1) for which you want to change the assignment, and rotate the Parameter wheel or press the [INC]/[DEC] buttons to modify the patching. 3 Press [ENTER] to confirm the change. Tip: • By default, you can also use the Encoders to select Input Channel sources. Rotate the Encoders to display the In Patch/In Patch page and select sources. Press the Encoder push switches to confirm the changes. • To restore the default patching, recall Input Patch memory #00 (see page 168). Patching Omni Outs By default, the Omni Outs are patched as follows: • OMNI OUT connectors 1-8 Aux Sends 1-8 • OMNI OUT connectors 9-10 Stereo Bus L & R • OMNI OUT connectors 11-12 ..........Control Room Monitor L & R Follow the steps below to view or change the patching. 1 Press the DISPLAY ACCESS [OUTPUT PATCH] button repeatedly until the following page appears. 1 Signals that are currently assigned to the OMNI OUT connectors are shown in the param- eter boxes (1) underneath the connector numbers. The parameter indicators are explained below No assignment • BUS1-BUS8 Bus 1-8 signals • AUX1-AUX8 Aux Send 1-8 Signals • ST L/R Stereo Bus signals • INS CH1-INS CH48 Input Channels 1-48 Insert Outs • INS BUS1-INS BUS8 Bus 1-8 Insert Outs • INS AUX1-INS AUX8 Aux Send 1-8 Insert Outs • INS ST-L/ST-R Stereo Bus Insert Outs DM1000-Owner's Manual