Yamaha DM1000 Owner's Manual - Page 267

Cascading Consoles 267 4 Assign the Bus signals to the slot channels that are used for the cascade connection. The following signals are available: Options CAS BUS1-BUS8 CAS AUX1-AUX8 CAS ST-L, CAS ST-R CASSOLOL, CASSOLOR Description Bus 1-8 Cascade Outs Aux Bus 1-8 Cascade Outs Stereo Bus L & R Cascade Outs Solo Bus L & R Cascade Outs The following display page is an example of integrating Bus 1-8, Aux Send 1-4, Stereo Bus, and Solo Bus signals via two 8-channel digital I/O cards (such as MY8-AT). Tip: Patching may vary depending on the type and number of buses used for the cascade connection. Note: Since the number of channels available on the digital I/O cards is limited, only Aux Sends 1-4 are cascaded in this example. Using a 16-channel digital I/O card (such as MY16-AT) enables you to cascade all buses. 5 On the master unit, press the DISPLAY ACCESS [INPUT PATCH] button repeatedly until the In Patch | Cascade In page appears. 6 Select the Input Channels on the master unit to which the Bus signals are input from the Slave unit. The following display page is an example of receiving the slave unit's Bus 1-8, Aux Send 1-4, Stereo Bus, and Solo Bus signals via two 8-channel digital I/O cards (such as MY8-AT). 19 Note: Be sure to patch the slave Bus signals to the same Buses on the master unit. Incorrect patching will result in an incorrect cascade connection. DM1000-Owner's Manual Other Functions