Yamaha DM1000 Owner's Manual - Page 46
Slot1/slot2, Wc In, 2trd1, Int 44.1k, Int 48k, Int 88.2
View all Yamaha DM1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
46 Chapter 4-Connections and Setup The source select button indicators are explained below: A usable wordclock signal is present at this input, and it is in sync with the current DM1000 internal clock. No wordclock signal is present at this input. A usable wordclock signal is present at this input, but it is out of sync with the current DM1000 internal clock. This input is the currently-selected wordclock source. This input was selected as the wordclock source, but no usable signal was received. This input cannot be selected as the wordclock source because (a) a wordclock signal cannot be sourced from this input on this type of I/O card, or (b) no I/O card is installed. Tip: • The FS box displays the sampling frequency at which the DM1000 is currently operating. • The SLOT TYPE column displays the names of any installed I/O cards. • The IN and OUT columns indicate the number of input and output channels available for each installed I/O card. 2 Use the cursor buttons to move the cursor to a source, then press [ENTER]. The following are possible wordclock sources: • SLOT1/SLOT2 These buttons select the inputs from the digital I/O cards installed in Slots 1 and 2 as the wordclock source. Inputs are selected in pairs (odd and even numbers in this order). The SLOT TYPE column displays the names of any installed I/O cards. The number of pairs depends on the type of I/O card installed. • WC IN This button selects the wordclock signal input at the WORD CLOCK IN connector on the rear panel. • 2TRD1 This button selects the 2TR IN DIGITAL 1 input as the wordclock source. • 2TRD2 This button selects the 2TR IN DIGITAL 2 input as the wordclock source. • INT 44.1k, INT 48k, INT 88.2, INT 96k........ These buttons select the internal clock generator as the wordclock source. The DM1000 will function as the wordclock master. Note: To transfer data at higher sampling frequencies (88.2 kHz or 96 kHz) between the DM1000 and connected external devices, you need to set the data transfer format. See page 57 for more information. Tip: If an external wordclock source fails, the DM1000 automatically switches to its internal clock generator at the closest frequency (INT 44.1k, INT 48k, INT 88.2k, INT 96k). DM1000-Owner's Manual