Yamaha DM1000 Owner's Manual - Page 241

Assigning Parameters to Control Changes for Real-time Control 241 4 Move the cursor to the MODE parameter's TABLE button (1), then press [ENTER]. The MODE parameter determines which MIDI messages are transmitted when DM1000 parameters are adjusted. The following options are available for the MODE parameter: • TABLE MIDI Control Change messages are transmitted in accordance with the assignments on this page. • NRPN The assignments on the Ctl Asgn page are ignored, and predefined NRPNs (Non Registered Parameter Numbers) are transmitted for remote control. Tip: NRPNs are special MIDI messages that combine three different Control Changes. They enable you to control many parameters on a single MIDI Channel. 5 Move the cursor to a parameter box in the No. (CH) column, then rotate the Parameter wheel or press the [INC]/[DEC] buttons to select the Control Changes to which you want to assign parameters. You can assign parameters to up to 16-channel Control Changes on the Ctl Asgn page, regardless of the MIDI Channels currently selected for transmission and reception. Skip Steps 5 and 6 if you turned on the NRPN button in Step 4. 6 Select parameters in the parameter boxes in the three PARAMETER columns. Select a parameter group in the parameter box in the first PARAMETER column, and specify the desired values in the parameter boxes in the second and third PARAMETER columns. The following parameters and values are available: HIGH NO ASSIGN FADER H FADER L MID - CHANNEL MASTER AUX1 SEND AUX2 SEND AUX3 SEND AUX4 SEND AUX5 SEND AUX6 SEND AUX7 SEND AUX8 SEND BUS TO ST CHANNEL MASTER AUX1 SEND AUX2 SEND AUX3 SEND AUX4 SEND AUX5 SEND AUX6 SEND AUX7 SEND AUX8 SEND BUS TO ST LOW - INPUT1-48 BUS1-8/AUX1-8/STEREO INPUT1-48 BUS1-8 INPUT1-48 BUS1-8/AUX1-8/STEREO INPUT1-48 BUS1-8 MIDI 18 DM1000-Owner's Manual