Yamaha DM1000 Owner's Manual - Page 138
Using the Oscillator for Surround Monitor, SNAP TO SPL85, ON/OFF, ROTATE, Speaker buttons
View all Yamaha DM1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 138 highlights
138 Chapter 11-Surround Functions • SNAP TO SPL85........... Turning on this button resets the [MONITOR LEVEL] control setting to the value stored by the SET SPL85 button. Note: The Surround Monitor Mute and Solo functions are reset to the default condition when you change the Surround mode. 3 Move the cursor to the SET SPL button, then press [ENTER] to turn on the button. The volume setting of the [MONITOR LEVEL] control is calibrated to 85 dB SPL and stored. If you store the cinema standard level in this way, moving the cursor to the SNAP TO SPL85 button and pressing [ENTER] always restores the stored value, even after you adjust the [MONITOR LEVEL] control. Tip: When the SET SPL button is turned on, the standard value (85.0 dB ) indicated in the MONITOR LEVEL box is applied to the stored [MONITOR LEVEL] control setting. Using the Oscillator for Surround Monitor The DM1000 features a dedicated Oscillator that enables you to check the output and sound of the surround sound speakers. You can send the Oscillator signal to certain speakers or to each speaker in turn. This function is useful when you wish to check the volume balance and phase of the surround monitor speakers. Tip: This Oscillator is available only for Surround monitoring. 1 Press the MONITOR [DISPLAY] button repeatedly until the Monitor | Surr Setup page appears. The SPEAKER SETUP section enables you to turn the Oscillator on or off and specify the signal destination. 1 A SPEAKER SETUP You can select the Oscillator waveform and the speakers to which the Oscillator signal is sent. • OSC This parameter selects the Oscillator waveform. • ON/OFF This button turns the Oscillator on or off. • ROTATE When the ROTATE button is on, the Oscillator signal is output by each speaker in turn, with an interval of five seconds (3-second signal and 2-second pause). • (Speaker) buttons These buttons turn the Oscillator on or off for each speaker. DM1000-Owner's Manual