Yamaha DM1000 Owner's Manual - Page 22
MONITOR TR D1] button
View all Yamaha DM1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
22 Chapter 2-Control Surface & Rear Panel MONITOR Section 1 2 4 7 MONITOR DISPLAY SOLO CLEAR 2TR D1 2TR D2 STEREO SLOT BUS 0 10 MONITOR DIMMER TALKBACK LEVEL 9J K 3 5 6 8 A [DISPLAY] button This button displays a Monitor page, enabling you to adjust monitor settings (see page 115 and 131). B [SOLO] indicator This indicator flashes when a single or multiple channels are soloed. C [CLEAR] button This button "unsolos" all soloed Channels. D [2TR D1] button E [2TR D2] button F [STEREO] button These buttons select the Control Room Monitor output signal. When the [2TR D1] button indicator is lit, the signal at the 2TR OUT DIGITAL 1 jack is selected. When the [2TR D2] button indicator is lit, the signal at the 2TR OUT DIGITAL 2 jack is selected. When the [STEREO] button indicator is lit, the Stereo Bus signal is selected. If you change the parameter setting on the Monitor | Solo/C-R page (see page 116), you can monitor the OMNI IN signal, instead of the 2TR IN DIGITAL signal, when you press the [2TR D1] or [2TR D2] button. G [SLOT] button H [BUS] button These buttons select the Surround Monitor signal source. When the [BUS] button indicator is lit, the Bus 1-8 signals are selected. When the [SLOT] button indicator is lit, the signals from Slots 1/2 are selected. (See page 131 for more information on the Surround Monitor.) I [DIMMER] button This button activates the Dimmer function, which lowers the Monitor and Surround Monitor signals. This function is convenient when you wish to talk in the control room during mixdown. The [TALKBACK] button indicator flashes while the Talkback function is active (see page 116). J [TALKBACK] button This button turns on the Talkback function. While the button indicator is lit, the Talkback mic signal is sent to any desired Bus or Slot (see page 119). K MONITOR LEVEL control This control adjusts the monitor level. Note: • The DM1000 allows you to patch source signals to any output jack (other than the PHONES jack). Therefore, the console does not feature a dedicated monitor output jack. Instead, you can route monitoring signals to any desired output jack (typically to OMNI OUT jacks 1-12). • By default, monitoring signals are assigned to OMNI OUT jacks 11 and 12. DM1000-Owner's Manual