Yamaha DM1000 Owner's Manual - Page 218

218 Chapter 17-Remote Control Setting Send Levels You can adjust Pro Tools Send (A-E) send levels as follows. 1 Press the AUX SELECT [AUX 1]-[AUX 5] buttons to select the desired Sends (A-E). 2 Rotate the Encoders for the desired channels. You can set Send levels by rotating the Encoders if faders, Encoders, and [ON] buttons are in Flip mode. Refer to "Flip Mode" for more information. Muting Sends A-E You can mute Sends by pressing the [ON] buttons if faders, Encoders, and [ON] buttons are in Flip mode. Refer to "Flip Mode" for more information. Panning Sends A-E You can pan only Sends assigned to stereo destinations by rotating the Encoders if faders, Encoders, and [ON] buttons are in Flip mode. Refer to the next section for more information. Flip Mode In Flip mode, you can use the faders, Encoders, and [ON] buttons to control send levels, pre/post positions, and mute settings as shown in the following table. Control Faders Encoders Encoder push-switches [ON] buttons Normal mode Channel level Channel pan/send level Encoder mode is Pan: inactive; Encoder mode is Send level: Send pre/post Channel mute Flip Mode Send level Send pan Send pre/post Send mute 1 Press the FADER MODE [FADER/AUX] button. The FADER MODE [FADER] and [AUX] indicators flash alternately, and the SELECT ASSIGN parameter on the display indicates "FLIP." 2 Press the AUX SELECT [AUX 1]-[AUX 5] buttons to select the desired Sends (A-E). The button indicator of the selected send lights up. 3 Use the faders, Encoders, and [ON] buttons to control the currently-selected send. For stereo Aux input channels, you can set the left and right panpots individually. To do this, press the ENCODER MODE [PAN] button repeatedly. When the button indicator is lit continuously, you can set the left panpot. When the button indicator is flashing, you can set the right panpot. DM1000-Owner's Manual