Yamaha DM1000 Owner's Manual - Page 116

116 Chapter 10-Control Room Monitoring Control Room Monitor and Solo Setup For control room monitoring and solo setup, press the MONITOR [DISPLAY] button repeatedly until the Monitor | Solo/C-R page appears. 2 3 1 4 5 7 6 8 9 J This page contains the following parameters: A SOLO This parameter turns the Solo function on or off. By default, it is set to Enabled. B MODE This parameter determines how the Solo function works. There are two options. The setting affects only Input Channels. • RECORDING In Recording Solo mode, soloed Input Channel signals are fed to the Solo bus and output via the Control Room Outputs. Other buses (Stereo bus and Bus 1-8) are unaffected by this mode. • MIXDOWN In Mixdown Solo mode, soloed Input Channel signals are fed to the Stereo bus and output via the Control Room Outputs. Unsoloed Input Channels are not fed to the Stereo bus while the Solo function is enabled. Tip: • Recording Solo mode is convenient when you wish to monitor certain Input Channels while recording, since the Stereo bus and Bus 1-8 signals are unaffected • Mixdown Solo mode is useful when you wish to mute unsoloed Input Channels and feed soloed Input Channel signals to the Stereo bus during mixdown. C SEL MODE This parameter determines how the Input Channels will be soloed when you press the [SOLO] button of each Channel. There are two options. • MIX SOLO In Mix Solo mode, any number of channels can be soloed simultaneously. • LAST SOLO In Last Solo mode, only one channel can be soloed at a time by pressing the [SOLO] button. The Solo function that was previously enabled for channels is automatically cancelled. D LISTEN This parameter determines the source of the Input Channel Solo signal: Pre Fader or Post Pan. This parameter is effective only in Recording Solo mode. DM1000-Owner's Manual