Yamaha DM1000 Owner's Manual - Page 139

Surround Monitoring 139 • (SW Phase) button This button reverses the phase of the signal out- put to the Subwoofer (SW). 2 Make sure that the Speaker button ( ) for the speaker to which you want to output the Oscillator signal is turned on. If the button is off, move the cursor to the button, then press [ENTER] to turn it on. 3 Move the cursor to the OSC. parameter box, then rotate the Parameter wheel or press the [INC]/[DEC] buttons to select one of the following Oscillator waveforms. • PINK NOISE Pink noise • 500-2 kH Pink noise through a 500 Hz to 2 kHz BPF • 1 kHz 1 kHz sinewave • 50 Hz 50 Hz sinewave 4 Move the cursor to the ON/OFF button, then press the [ENTER] or [INC]/[DEC] buttons to turn the Oscillator on. The speaker specified in Step 2 outputs the Oscillator signal. If necessary, adjust the speaker volume balance in the MONITOR ALIGNMENT section on the Surr Setup page (see page 136). Patching Slot Inputs to Surround Channels You can patch individual Slot Inputs to Surround Monitor Channels as follows. 1 Make sure that the DM1000 is in the same Surround mode as the monitoring source. 2 Press the MONITOR [SLOT] button. Slot 1 or 2 Input is selected as the surround monitor source. 3 Press the MONITOR [DISPLAY] button repeatedly until the Monitor | Surr Patch page appears. This page enables you to make the Slot Input to Surround Monitor Channel assignment. 11 Surround Functions 4 Move the cursor to a patch parameter for which you want to change the assignment, and rotate the Parameter wheel to select a slot channel to be assigned to the Surround Monitor channel. To assign no channels, select "-." Set all unnecessary channels to "-." DM1000-Owner's Manual