Yamaha DM1000 Owner's Manual - Page 88
Attenuating Output Signals, Press the DISPLAY ACCESS [SETUP] button repeatedly until the Setup | Out
View all Yamaha DM1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 88 highlights
88 Chapter 7-Bus Outs Attenuating Output Signals To attenuate the DM1000's output signals, display the EQ | Out Att page and adjust the Stereo Out and Bus Out 1-8 attenuators individually. If necessary, you can also select Output and I/O card channels and specify the amount of attenuation. This technique is convenient when you want to attenuate output signals quickly, regardless of the source signal patching. 1 Press the DISPLAY ACCESS [SETUP] button repeatedly until the Setup | Output Att page appears. 1 2 2 Move the cursor in the left column (1), then scroll the list up or down using the Parameter wheel to select the desired output or slot channel for which you want to adjust attenuation. The following outputs and slot channels can be selected: • OMNI OUT 1-12 OMNI OUT connectors 1-12 • SLOT 1-1 through 1-16...........Channels 1-16 of Slot 1 • SLOT 2-1 through 2-16...........Channels 1-16 of Slot 2 3 Move the cursor to the parameter value in the right column (2), then rotate the Parameter wheel or press the [INC]/[DEC] buttons to set the amount of attenuation. The amount of attenuation can be set from 0 dB to -9 dB. Tip: To reset the attenuation amount of all Output Channels to 0 dB, move the cursor to the INITIALIZE button, then press [ENTER]. DM1000-Owner's Manual