Yamaha DM1000 Owner's Manual - Page 183
Creating a Time Signature Map
View all Yamaha DM1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 183 highlights
Setting Up for Automix Recording 183 4 If you select MIDI CLOCK, press the DISPLAY ACCESS [SETUP] button repeatedly until the Setup | MIDI/Host page appears (see page 236). Then, in the Rx PORT parameter box, specify the port or slot that receives MIDI Clock. Tip: • If you select the MIDI CLOCK source, Automix will respond to MIDI Start, Stop, and Continue messages. • An Automix will play back correctly even if the frame rate differs from that used when the Automix was originally recorded. However, an Automix recorded using MIDI Clock and an Automix recorded using other timecode sources are not compatible with one another. Creating a Time Signature Map If you selected the MIDI CLOCK source, you must specify the initial time signature and any time signature changes that follow, according to the song. (If you do not do this, the song timing and Automix position may not match when playback starts in mid-song.) 1 Press the DISPLAY ACCESS [SETUP] button repeatedly until the Setup | Time Sig page appears. This page enables you to specify a measure number in the MEAS column and the time signature in the TIME column. By default, 4/4 is set in the first measure. 2 To change the initial time signature, move the cursor to the TIME value in the first measure, and use the Parameter wheel or [INC]/[DEC] buttons to select the desired time signature. 3 To insert a time signature change, specify the desired measure number in an empty box in the MEAS column, and specify the corresponding time signature in the TIME column. To delete a time signature change, select it, then press [ENTER]. You cannot delete the initial time signature entry at measure #1. 16 DM1000-Owner's Manual Automix