Yamaha DM1000 Owner's Manual - Page 232
SLOT1, REMOTE, cursor to the PORT parameter box, then rotate the Parameter wheel to select
View all Yamaha DM1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 232 highlights
232 Chapter 17-Remote Control 3 Press the DISPLAY ACCESS [SETUP] button repeatedly until the Setup | MIDI/Host page appears. 1 4 Move the cursor to either the MMC button or P2 button in the MACHINE CONTROL section (1) to specify the remote control method, then press the [ENTER] button. In the MACHINE CONTROL section, you can also select the type of commands used on the Remote | Machine Control page. The MMC button selects MMC commands, and the P2 button select the P2 protocol. 5 If the MMC button is turned on, press the cursor [ ] button to move the cursor to the PORT parameter box, then rotate the Parameter wheel to select the MMC destination. The following ports and slots are available as the MMC destination. • MIDI MIDI port • USB USB port • SLOT1 Slot 1 with an MY8-mLAN (mLAN card) installed • REMOTE REMOTE connector If USB or SLOT 1 is selected, move the cursor to the adjacent parameter box (on the right), and select one of eight ports. 6 Move the cursor to the DEVICE ID parameter box, then rotate the Parameter wheel to set the DM1000 MMC Device ID to the same ID number as the external device. MMC commands are effective on devices that use the same Device ID. Therefore, the DM1000's MMC Device ID needs to match the ID of the devices you wish to control. DM1000-Owner's Manual