Yamaha DM1000 Owner's Manual - Page 32
Selecting Channels, layer that includes the desired channel see
View all Yamaha DM1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
32 Chapter 3-Operating Basics Selecting Channels The SELECTED CHANNEL controls enable you to edit main mix parameters for a channel selected from the Input Channels and Output Channels (Aux Outs, Bus Outs, and Stereo Out). To select a channel for editing using the SELECTED CHANNEL controls, follow the steps below: 1 Press the corresponding LAYER button to select a layer that includes the desired channel (see page 31). SELECTED CHANNEL ROUTING EQUALIZER DISPLAY DISPLAY 1 2 3 4 HIGH Q HIGH MID 5 6 FREQUENCY LOW MID 7 8 STEREO DIRECT GAIN LOW 2 Use the corresponding [SEL] button or fader to select the desired Input or Output Channel. The channel is selected and the [SEL] button indicator GRAB lights up. If the Fader Touch Sense parameter is enabled on the Setup | Prefer2 page (see page 252), operating a fader selects the corresponding channel. The Channel's ID and Short name appear in the upper-left corner of the display. If the currently-displayed page contains a relevant channel parameter, the cursor moves to that parameter automatically. If the currently-displayed page contains no such parameter, a page that does contain such a parameter is selected automatically. Tip: For paired Input or Output Channels, the channel for which you pressed the [SEL] button is selected, and its indicator lights up. The [SEL] button indicator of the paired partner flashes. 3 To select the Stereo Out, press the STEREO [SEL] button or touch the [STEREO] fader. Repeatedly pressing the STEREO [SEL] button toggles between the Stereo Out left and Stereo Out right channels. If the currently-displayed page contains a relevant Stereo Out parameter, the cursor moves to that parameter automatically. If the currently-displayed page contains no such parameter, a page that does contain such a parameter is selected automatically. Tip: If the Auto Channel Select parameter is enabled on the Setup | Prefer1 page (see page 250), operating a fader or Encoder, or turning on a [SOLO] or [ON] button selects the corresponding channel. DM1000-Owner's Manual