Yamaha DM1000 Owner's Manual - Page 91

Aux Sends 91 8 Aux Sends This chapter describes how to control Aux Out 1-8. Aux Out 1-8 The Aux Out 1-8 section mixes signals routed from the Input Channels to the corresponding Aux Sends, processes them using on-board EQ, compressor, etc., then routes them to the specified internal effects processors, output connectors or I/O card connectors. The DM1000 features eight Aux Sends, which can be used to send signals to the internal and external effects processors and monitors. The following diagram illustrates the Aux Out 1-8 signal flow. (Gain Reduction) (Out Meter) METER METER COMP INSERT ATT METER 4BAND EQ INSERT ON INSERT LEVEL OUTPUT DELAY METER AUX 1(...8) 8 AUX 1 AUX 8 OUTPUT PATCH Aux Sends TO INPUT PATCH AUX 1(...8) • INSERT • ATT (Attenuator) • 4 BAND EQ (4-band equalizer) • COMP (Compressor) • ON (On/Off) • LEVEL • OUTPUT DELAY (Output delay) • METER These parameters are the same as the Stereo Out and Bus Out 1-8 (see page 79). Tip: You can also pair adjacent odd-even Aux Sends (in this order) for stereo Aux operation. Note: With the default setting, Aux Out 1-8 are patched to OMNI OUT connectors 1-8 and Aux Out 1-4 are patched to internal effects processors 1-4. However, you can change this patching on the Out Patch page. DM1000-Owner's Manual