Dell MX5108n OS10 Enterprise Edition User Guide for PowerEdge MX IO Modules Re - Page 118
link-bundle-utilization, mode
View all Dell MX5108n manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 118 highlights
Default Command Mode Usage Information Example VLAN 1 CONFIGURATION FTP, TFTP, MAC ACLs, and SNMP operations are not supported - IP ACLs are supported on VLANs only. The no version of this command deletes the interface. OS10(config)# interface vlan 10 OS10(conf-if-vl-10)# Supported Releases 10.2.0E or later link-bundle-utilization Configures link-bundle utilization. Syntax Parameters Default Command Mode Usage Information Example link-bundle-utilization trigger-threshold value value - Enter the percentage of port-channel bandwidth that triggers traffic monitoring on port-channel members (0 to 100). Disabled CONFIGURATION None OS10(config)# link-bundle-utilization trigger-threshold 10 Supported Releases 10.2.0E or later mode Configures a front-panel unified port group to operate in Fibre Channel or Ethernet mode, or a QSFP28-DD or QSFP28 port group to operate in Ethernet mode, with the specified speed on activated interfaces. Syntax mode {Eth {100g-2x | 100g-1x | 50g-2x | 40g-2x | 40g-1x | 25g-8x [fabricexpander-mode] | 25g-4x | 10g-8x | 10g-4x} | FC {32g-4x | 32g-2x | 32g-1x | 16g-4x}} Parameters • mode Eth - Configure a port group in Ethernet mode and set the speed to: - 100g-2x - Split a QSFP28-DD port into two 100GE interfaces. - 100g-1x - Reset a QSFP28 port group to 100GE mode. - 50g-2x - Split a QSFP28 port into two 50GE interfaces. - 40g-2x - Split a port group into two 40GE interfaces. - 40g-1x - Set a port group to 40G mode for use with a QSFP+ 40GE transceiver. - 25g-8x fabric-expander-mode - Split a QSFP28-DD port into eight 25GE interfaces for connection to a Fabric Expander. - 25g-8x - Split a port group into eight 25GE interfaces. - 25g-4x - Split a port group into four 25GE interfaces. - 10g-8x - Split a port group into eight 10GE interfaces. - 10g-4x - Split a port group into four 10GE interfaces. • mode FC - Configure a port group in Fibre Channel mode and set the speed to: 118 Interfaces