Dell MX5108n OS10 Enterprise Edition User Guide for PowerEdge MX IO Modules Re - Page 340

Command Mode Usage Information INTERFACE • This command sets an interface in Host mode to perform IPv6 stateless auto-configuration by discovering prefixes on local links, and adding an EUI-64 based interface identifier to generate each IPv6 address. The command disables IPv6 forwarding. Addresses are configured depending on the prefixes received in router advertisement messages. • The no version of this command disables IPv6 address autoconfiguration, resets the interface in Router mode, and re-enables IPv6 forwarding. Example OS10(config)# interface ethernet 1/1/1 OS10(conf-if-eth1/1/1)# no switchport OS10(conf-if-eth1/1/1)# ipv6 address autoconfig OS10(conf-if-eth1/1/1)# Supported Releases 10.3.0E or later ipv6 address dhcp Enables DHCP client operations on the interface. Syntax Parameters Defaults Command Mode Usage Information Example ipv6 address dhcp None None INTERFACE The no version of this command disables the DHCP operations on the interface. OS10(config)# interface mgmt 1/1/1 OS10(conf-if-ma-1/1/1)# ipv6 address dhcp Supported Releases 10.3.0E or later ipv6 enable Enables and disables IPv6 forwarding on an interface configured with an IPv6 address. Syntax Parameters Defaults Command Mode Usage Information ipv6 enable None None INTERFACE • The no version of this command disables IPv6 forwarding. • Use this command to disable and re-enable IPv6 forwarding on an interface for security purposes or to recover from a duplicate address discovery (DAD) failure. Example OS10(config)# interface ethernet 1/1/1 OS10(conf-if-eth1/1/1)# ipv6 address 2111:dddd:0eee::22/128 OS10(conf-if-eth1/1/1)# no ipv6 enable OS10(conf-if-eth1/1/1)# ipv6 enable Supported Releases 10.3.0E or later 340 Layer 3