Dell MX5108n OS10 Enterprise Edition User Guide for PowerEdge MX IO Modules Re - Page 552
seq permit icmp
View all Dell MX5108n manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 552 highlights
- capture - (Optional) Enter the capture packets the filter processes. - cos - (Optional) Enter the CoS value, from 0 to 7. - count - (Optional) Enter the count packets the filter processes. - byte - (Optional) Enter the count bytes the filter processes. - vlan - (Optional) Enter the VLAN number, from 1 to 4093. Default Command Mode Usage Information Example Not configured MAC-ACL OS10 cannot count both packets and bytes; when you enter the count byte options, only bytes increment. The no version of this command removes the filter, or use the no seq sequence-number command if you know the filter's sequence number. OS10(config)# mac access-list macacl OS10(conf-mac-acl)# seq 10 permit 00:00:00:00:11:11 00:00:11:11:11:11 any cos 7 OS10(conf-mac-acl)# seq 20 permit 00:00:00:00:11:11 00:00:11:11:11:11 any vlan 2 Supported Releases 10.2.0E or later seq permit icmp Assigns a sequence number to allow ICMP messages while creating the filter Syntax seq sequence-number permit icmp [A.B.C.D | A.B.C.D/x | any | host ip-address] [A.B.C.D | A.B.C.D/x | any | host ip-address] [capture | count [byte] | dscp value| fragment] Parameters • sequence-number - Enter the sequence number to identify the route-map for editing and sequencing number, from 1 to 16777214. • A.B.C.D - Enter the IP address in dotted decimal format. • A.B.C.D/x - Enter the number of bits that must match the dotted decimal address. • any - (Optional) Set all routes are which subject to the filter: - capture - (Optional) Capture packets the filter processes. - count - (Optional) Count packets the filter processes. - byte - (Optional) Count bytes the filter processes. - dscp value - (Optional) Permit a packet based on the DSCP values, from 0 to 63. - fragment - (Optional) Use ACLs to control packet fragments. • host ip-address - (Optional) Enter the IP address to use a host address only. Default Command Mode Usage Information Example Not configured IPV4-ACL OS10 cannot count both packets and bytes; when you enter the count byte options, only bytes increment. The no version of this command removes the filter, or use the no seq sequence-number command if you know the filter's sequence number. OS10(config)# ip access-list egress OS10(conf-ipv4-acl)# seq 5 permit icmp any any capture session 1 Supported Releases 10.2.0E or later 552 Access Control Lists