Dell MX5108n OS10 Enterprise Edition User Guide for PowerEdge MX IO Modules Re - Page 455

Command Mode Usage Information Example DHCP-POOL The host address is the IP address used by the client machine for DHCP. OS10(conf-dhcp-Dell)# host 20.1.1.100 Supported Releases 10.2.0E or later ip dhcp server Enters DHCP mode. Syntax ip dhcp server Parameters None Default Not configured Command Mode CONFIGURATION Usage Information This command is used to enter DHCP mode. Example OS10(config)# ip dhcp server OS10(conf-dhcp)# Supported Releases 10.2.0E or later ip helper-address Configure the DHCP server address. Forwards UDP broadcasts received on an interface to the DHCP server. You can configure multiple helper addresses per interface by repeating the same command for each DHCP server address. Syntax Parameters ip helper-address address • address - Enter the IPv4 address to forward UDP broadcasts to the DHCP server in the A.B.C.D format. Default Command Mode Usage Information Example (IPv4) Disabled INTERFACE The DHCP server is available on L3 interfaces only. The no version of this command returns the value to the default. OS10(config)# interface eth 1/1/22 OS10(conf-if-eth1/1/22)# ip helper-address 20.1.1.1 Supported Releases 10.2.0E or later lease Configures a lease time for the IP addresses in a pool. Syntax lease {infinite | days [hours] [minutes]} Parameters • infinite - Enter the keyword to configure a lease which never expires. • days - Enter the number of lease days (0 to 31). System management 455