Dell MX5108n OS10 Enterprise Edition User Guide for PowerEdge MX IO Modules Re - Page 522
deny udp
View all Dell MX5108n manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 522 highlights
- lt - Lesser than - neq - Not equal to - range - Range of ports, including the specified port numbers. • host ipv6-address - (Optional) Enter the IPv6 address to use a host address only. Default Command Mode Usage Information Example Not configured IPV6-ACL OS10 cannot count both packets and bytes; when you use the count byte options, only bytes increment. The no version of this command removes the filter. OS10(config)# ipv6 access-list ipv6test OS10(conf-ipv6-acl)# deny tcp any any capture session 1 Supported Releases 10.2.0E or later deny udp Configures a filter to drop user datagram protocol (UDP) packets meeting the filter criteria. Syntax Parameters deny udp [A.B.C.D | A.B.C.D/x | any | host ip-address [operator]] [A.B.C.D | A.B.C.D/x | any | host ip-address [operator]] [ack | fin | psh | rst | syn | urg] [capture |count [byte] | dscp value | fragment] • A.B.C.D - Enter the IP address in dotted decimal format. • A.B.C.D/x - Enter the number of bits to match to the dotted decimal address. • any - (Optional) Set all routes which are subject to the filter: - capture - (Optional) Capture packets the filter processes. - count - (Optional) Count packets the filter processes. - byte - (Optional) Count bytes the filter processes. - dscp value - (Optional) Deny a packet based on the DSCP values, from 0 to 63. - fragment - (Optional) Use ACLs to control packet fragments. - ack - (Optional) Set the bit as acknowledgement. - fin - (Optional) Set the bit as finish-no more data from sender. - psh - (Optional) Set the bit as push. - rst - (Optional) Set the bit as reset. - syn - (Optional) Set the bit as synchronize. - urg - (Optional) Set the bit set as urgent. • operator - (Optional) Enter a logical operator to match the packets on the specified port number. The following options are available: - eq - Equal to - gt - Greater than - lt - Lesser than - neq - Not equal to - range - Range of ports, including the specified port numbers. • host ip-address - (Optional) Enter the IP address to use a host address only. Default Not configured 522 Access Control Lists