Dell MX5108n OS10 Enterprise Edition User Guide for PowerEdge MX IO Modules Re - Page 654

OS10(config-pmap-queuing)# bandwidth percent 30 OS10(config-pmap-queuing)# exit OS10(config)# policy-map type queuing p2 OS10(config-pmap-queuing)# class c2 OS10(config-pmap-queuing)# bandwidth percent 70 OS10(config-pmap-queuing)# exit OS10(config)# system qos OS10(config-sys-qos)# trust-map dot1p dot1p_map1 OS10(config-sys-qos)# trust-map dscp dscp_map1 OS10(config-sys-qos)# qos-map traffic-class tc-q-map1 OS10(config-sys-qos)# ets mode on OS10(config-sys-qos)# service-policy input type qos pclass1 OS10(config-sys-qos)# service-policy output type queuing p1 View ETS configuration OS10# show qos interface ethernet 1/1/1 Interface unknown-unicast-storm-control : Disabled multicast-storm-control : Disabled broadcast-storm-control : Disabled flow-control-rx : Disabled flow-control-tx : Disabled ets mode : Disabled Dot1p-tc-mapping : dot1p_map1 Dscp-tc-mapping : dscp_map1 tc-queue-mapping : tc-q-map1 View QoS maps: traffic-class to queue mapping OS10# show qos maps Traffic-Class to Queue Map: tc-q-map1 queue 0 qos-group 0 queue 1 qos-group 1 Traffic-Class to Queue Map: dot1p_map1 qos-group 0 dot1p 0-3 qos-group 1 dot1p 4-7 DSCP Priority to Traffic-Class Map : dscp_map1 qos-group 0 dscp 0-31 qos-group 1 dscp 32-63 ETS commands ets mode on Enables ETS on an interface. Syntax ets mode on Parameter None Default Disabled Command Mode INTERFACE Usage Information Enable ETS on all switch interfaces in SYSTEM-QOS mode or on an interface or interface range in INTERFACE mode. The no version of this command disables ETS. Example OS10(config-sys-qos)# ets mode on Supported Releases 10.3.0E or later 654 Converged data center services