Dell MX5108n OS10 Enterprise Edition User Guide for PowerEdge MX IO Modules Re - Page 432

Create virtual router VRRP uses the VRID to identify each virtual router configured. Before using VRRP, you must configure the interface with the primary IP address and enable it. • Create a virtual router for the interface with the VRRP identifier in INTERFACE mode (1 to 255). vrrp-group vrrp-id • Delete a VRRP group in INTERFACE mode. no vrrp-group vrrp-id Configure VRRP OS10(config)# interface ethernet 1/1/5 OS10(conf-if-eth1/1/5)# vrrp-group 254 Verify VRRP OS10(conf-eth1/1/5-vrid-254)# do show running-configuration ... ! interface ethernet 1/1/5 ip address 10.10.10.1/24 ! vrrp-group 254 no shutdown ... Group version Configure a VRRP version for the system. Define either VRRPv2 - vrrp version 2, VRRPv3 - vrrp version 3, or vrrp version both to migrate a system from VRRPv2 to VRRPv3. • Configure the VRRP version for IPv4 in INTERFACE mode. vrrp version Configure VRRP version 3 OS10(config)# vrrp version 3 Use the vrrp version both command in Configuration mode to migrate from VRRPv2 to VRRPv3. When you set the VRRP version to vrrp version both, the switch sends and receives both VRRPv2 or VRRPv3 packets. 1 Set the switch with the lowest priority to vrrp version both. 2 Set the switch with the highest priority to vrrp version 3. 3 Set all switches from vrrp version both to vrrp version 3. Migrate IPv4 group from VRRPv2 to VRRPv3 OS10_backup_switch1(config)# vrrp version both OS10_backup_switch2(config)# vrrp version both Set master switch to VRRPv3 OS10_master_switch(config)# vrrp version 3 432 Layer 3