Dell MX5108n OS10 Enterprise Edition User Guide for PowerEdge MX IO Modules Re - Page 157

vfabric Configures a virtual fabric (vfabric). Enable the F_Port before configuring a vfabric. You can configure only one vfabric in F_Port mode. The vfabric becomes active only when you configure the vfabric with a valid VLAN and FC map. Do not use spanned VLAN as vfabric VLAN. Syntax vfabric fabric-ID Parameters fabric-ID - Enter the fabric ID, from 1 to 255. Defaults Not configured Command Mode CONFIGURATION Usage Information The no version of this command removes the vfabric. You can remove a vfabric only when it is not applied on any interfaces. Example OS10(config)# vfabric 100 Supported Releases 10.3.1E or later vfabric (interface) Applies an existing vfabric to an FC interface. Syntax Parameters Defaults Command Mode Usage Information vfabric fabric-ID fabric-ID - Enter the fabric ID, from 1 to 255. Not configured INTERFACE The no version of this command removes the vfabric from the FC interface. Example OS10(config)# interface fibrechannel 1/1/1 OS10(conf-if-fc1/1/1)# vfabric 100 Supported Releases 10.3.1E or later vlan Associate an existing VLAN ID to the vfabric to carry traffic. Create the VLAN ID before associating it to the vfabric. Do not use spanned VLAN as vfabric VLAN. Syntax vlan vlan-ID Parameters vlan-ID - Enter an existing VLAN ID. Defaults Not configured Command Mode Vfabric CONFIGURATION Usage Information The no version of this command removes the VLAN ID from the vfabric. Fibre channel 157