Dell MX5108n OS10 Enterprise Edition User Guide for PowerEdge MX IO Modules Re - Page 546
seq deny ipv6, seq deny tcp
View all Dell MX5108n manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 546 highlights
seq deny ipv6 Assigns a filter to deny IPv6 addresses while creating the filter. Syntax seq sequence-number deny ip [A::B | A::B/x | any | host ipv6-address] [A::B | A:B/x | any | host ipv6-address] [capture | count [byte] | dscp value | fragment] Parameters • sequence-number - Enter the sequence number to identify the route-map for editing and sequencing number, from 1 to 16777214. • A::B - Enter the IPv6 address in hexadecimal format separated by colons. • A::B/x - Enter the number of bits that must match the IPv6 address. • any - (Optional) Set all routes which are subject to the filter: - capture - (Optional) Capture packets the filter processes. - count - (Optional) Count packets the filter processes. - byte - (Optional) Count bytes the filter processes. - dscp value - (Optional) Deny a packet based on the DSCP values, from 0 to 63. - fragment - (Optional) Use ACLs to control packet fragments. • host ip-address - (Optional) Enter the IPv6 address to use a host address only. Default Command Mode Usage Information Example Not configured IPV6-ACL OS10 cannot count both packets and bytes; when you enter the count byte options, only bytes increment. The no version of this command removes the filter, or use the no seq sequence-number command if you know the filter's sequence number. OS10(config)# ipv6 access-list ipv6test OS10(conf-ipv6-acl)# seq 10 deny ipv6 any any capture session 1 Supported Releases 10.2.0E or later seq deny tcp Assigns a filter to deny TCP packets while creating the filter. Syntax Parameters seq sequence-number deny tcp [A.B.C.D | A.B.C.D/x | any | host ip-address [operator]] [[A.B.C.D | A.B.C.D/x | any | host ip-address [operator] ] [ack | fin | psh | rst | syn | urg] [capture | count [byte] | dscp value | fragment] • sequence-number - Enter the sequence number to identify the route-map for editing and sequencing number, from 1 to 16777214. • A.B.C.D - Enter the IP address in dotted decimal format. • A.B.C.D/x - Enter the number of bits that must match the dotted decimal address. • any - (Optional) Set all routes which are subject to the filter: - capture - (Optional) Capture packets the filter processes. - count - (Optional) Count packets the filter processes. - byte - (Optional) Count bytes the filter processes. 546 Access Control Lists