Dell MX5108n OS10 Enterprise Edition User Guide for PowerEdge MX IO Modules Re - Page 635
delay-restore, discovery-interface
View all Dell MX5108n manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 635 highlights
• vrf management - (Optional) Configures the management VRF instance for the backup IPv4 or IPv6 address. Default Command Mode Usage Information Example Not configured VLT-DOMAIN The no version of this command removes the IP address from the backup link. OS10(config)# vlt-domain 1 OS10(conf-vlt-1)# backup destination 10.16.151.110 vrf management OS10(config)# vlt-domain 1 OS10(conf-vlt-1)# backup destination ipv6 1::1 vrf management Supported Releases 10.3.1E or later delay-restore Configures a time interval to delay the bringing up of VLT ports after reload or peer-link restoration between the VLT peer switches. Syntax delay-restore seconds Parameters seconds - Enter a delay time, in seconds, to delay bringing up VLT ports after the VLTi device is reloaded, from 1 to 1200. Default 90 seconds Command Mode VLT-DOMAIN Usage Information Use this command to delay the system from bringing up the VLT port for a brief period to allow L3 routing protocols to converge. If the peer VLT device was up at the time the VLTi link failed, use this command after a VLT device is reloaded. The no version of this command resets the delay time to the default value. Example OS10(conf-vlt-1)# delay-restore 100 Supported Releases 10.3.0E or later discovery-interface Configures the interface to discover and connect to a VLT peer in the VLT interconnect (VLTi) link between peers. Syntax discovery-interface {ethernet node/slot/port[:subport]} Parameters ethernet - Enter the Ethernet interface information for the port on a VLT peer. You can also enter a range of interfaces separated by hyphens. Default None Command Mode VLT-DOMAIN Usage Information The VLT node discovery service auto-LAGs the discovery ports and creates VLTi interfaces. The no version of this command disables the discovery-interface configuration. Example OS10(config)# vlt-domain 1 OS10(conf-vlt-1)# discovery-interface ethernet 1/1/15 Virtual link trunking 635