Dell MX5108n OS10 Enterprise Edition User Guide for PowerEdge MX IO Modules Re - Page 424

show policy Displays policy information. Syntax Parameters Defaults Command Mode Usage Information Example show {ip | ipv6} policy [map-name] map-name - (Optional) Enter the name of a configured route map (up to 140 characters). None EXEC None OS10# show ip policy map-name Supported Releases 10.3.0E or later show route-map pbr-statistics Displays the current PBR statistics. Syntax show route-map [map-name] pbr-statistics Parameters map-name - (Optional) Enter the name of a configured route map (up to 140 characters). Defaults None Command Mode EXEC Usage Information None Example OS10# show route-map map1 pbr-statistics Supported Releases 10.3.0E or later Virtual routing and forwarding Virtual routing and forwarding (VRF) allows to partition a physical router into multiple virtual routers. The control and data plane are isolated in each virtual router (VR) so that traffic does not flow across VRs. VRF allows multiple instances of routing tables to co-exist within the same router at the same time. OS 10 supports a management VRF instance and a default VRF instance. You can add management ports to the management VRF instance. All the front panel ports and logical interfaces are part of the default VRF instance. Configure management VRF You can add only management interfaces to the management VRF instance. Before you assign the management interface to the management VRF instance, remove all the configured settings, including the IP address, on the management interface. 1 Enter the ip vrf management command in the CONFIGURATION mode. Use non-transaction-based configuration mode only. Do not use transaction-based mode. 2 Add the management interface by using the interface management command in the VRF CONFIGURATION mode. 424 Layer 3