Dell MX5108n OS10 Enterprise Edition User Guide for PowerEdge MX IO Modules Re - Page 442

Example enter or delete the virtual-address command. To guarantee that a VRRP group becomes Master, configure the VRRP group's virtual address with the same IP address as the interface's primary IP address and change the priority of the VRRP group to 255. You can ping the virtual addresses configured in all VRRP groups. The no version of this command deletes one or more virtual-addresses configured in the system. OS10(conf-eth1/1/5-vrid-254)# virtual address 10.1.1.15 Supported Releases 10.2.0E or later vrrp delay reload Sets the delay time for VRRP initialization after a system reboot. Syntax vrrp delay reload seconds Parameters seconds - Enter the number of seconds for the VRRP reload time (0 to 900). Default 0 Command Mode CONFIGURATION Usage Information VRRP delay reload time of zero seconds indicates no delays. This command configuration applies to all the VRRP configured interfaces. The no version of this command resets the value to the default. Example OS10(config)# vrrp delay reload 5 Supported Releases 10.4.0E(R1) or later vrrp-group Assigns a VRRP group identification number to an IPv4 interface or VLAN Syntax Parameters Default Command Mode Usage Information Example vrrp-group vrrp-id vrrp-id - Enter a VRRP group identification number (1 to 255). Not configured INTERFACE-VRRP The VRRP group only becomes active and sends VRRP packets when you configure a virtual IP address. When you delete the virtual address, the VRRP group stops sending VRRP packets. The no version of this command removes the vrrp-group configuration. OS10(conf-if-eth1/1/5)# vrrp-group 254 Example (VLAN) OS10(conf-if-vl-10)# vrrp-group 5 Supported Releases 10.2.0E or later vrrp-ipv6-group Assigns a VRRP group identification number to an IPv6 interface. Syntax Parameters vrrp-ipv6-group vrrp-id vrrp-id - Enter a VRRP group identification number (1 to 255). 442 Layer 3