Dell MX5108n OS10 Enterprise Edition User Guide for PowerEdge MX IO Modules Re - Page 56

management route Configures an IPv4/IPv6 static route used by the Management port. Repeat the command to configure multiple management routes. Syntax management route {ipv4-address/mask | ipv6-address/prefix-length} {forwardingrouter-address | managementethernet} Parameters • ipv4-address/mask - Enter an IPv4 network address in dotted-decimal format (A.B.C.D), then a subnet mask in /prefix-length format (/xx). • ipv6-address/prefix-length - Enter an IPv6 address in x:x:x:x::x format with the prefix length in /x format (prefix range is /0 to /128). • forwarding-router-address - Enter the next-hop IPv4/IPv6 address of a forwarding router (gateway) for network traffic from the management port. • managementethernet - Configure the Management port as the interface for the route; forces the route to be associated with the management interface. Default Command Mode Usage Information Example (IPv4) Not configured CONFIGURATION Management routes are separate from IP routes and are only used to manage the system through the management port. To display the currently configured IPv4 and IPv6 management routes, enter the show ip management-route and show ipv6 management-route commands. Warning: Avoid configuring an IPv4 or IPv6 address and a static route for the management interface that conflict with an IPv4 or IPv6 address and static route on a front-end port interface. OS10(config)# management route 10.10.20.0/24 10.1.1.1 OS10(config)# management route 172.16.0.0/16 managementethernet Example (IPv6) OS10(config)# management route 10::/64 10::1 Supported Releases 10.2.2E or later move Moves or renames a file on the config or home system directories. Syntax Parameters move [config: | home: | usb:] • config: - Move from configuration directory (config://filepath). • home: - Move from home directory (home://filepath). • usb: - Move from USB file system (usb://filepath). Default Command Mode Usage Information Example Not configured EXEC Use the dir config command to view the directory contents. OS10# move config://startup.xml config://startup-backup.xml Example (dir) OS10# dir config 56 Getting Started