Dell MX5108n OS10 Enterprise Edition User Guide for PowerEdge MX IO Modules Re - Page 146

Command Mode Usage Information VLAN INTERFACE The no version of this command disables the FC map configuration. Example OS10(config)# interface vlan 3 OS10(conf-if-vl-3)# fip-snooping fc-map 0xEFC64 Supported Releases 10.4.0E(R1) or later fip-snooping port-mode fcf Sets the FIP snooping port mode to FCF for interfaces. Syntax fip-snooping port-mode fcf Parameters None Defaults ENode port mode Command Mode INTERFACE Usage Information By default, the port mode of an interface is set to ENode. Use this command to change the port mode to FCF. You can set the port mode to FCF only after enabling the FIP snooping feature. The no version of this command resets the port mode to ENode. Example OS10(config)# interface ethernet 1/1/32 OS10(conf-if-eth1/1/32)# fip-snooping port-mode fcf Supported Releases 10.4.0E(R1) or later member (alias) Add members to existing FC aliases. Identify a member by an FC alias, a World Wide Name (WWN), or an FC ID. Syntax member {wwn wwn-ID | fc-id fc-id} Parameters • wwn-ID - Enter the WWN name. • fc-id - Enter the FC ID name. Defaults Command Mode Usage Information Not configured Alias CONFIGURATION The no version of this command removes the member from the FC alias. Example OS10(config)# fc alias test OS10(config-fc-alias-test)# member wwn 21:00:00:24:ff:7b:f5:c9 OS10(config-fc-alias-test)# member wwn 20:25:78:2b:cb:6f:65:57 Supported Releases 10.3.1E or later 146 Fibre channel