Dell MX5108n OS10 Enterprise Edition User Guide for PowerEdge MX IO Modules Re - Page 298
BGP commands, activate, add-path
View all Dell MX5108n manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 298 highlights
1 Enable soft-reconfiguration for the BGP neighbor and BGP template in ROUTER-BGP mode. BGP stores all the updates that the neighbor receives but does not reset the peer-session. Entering this command starts the storage of updates, which is required to do inbound soft reconfiguration. neighbor {ip-address} soft-reconfiguration inbound 2 Enter Address Family mode in ROUTER-NEIGHBOR mode. address-family {[ipv4 | ipv6] [unicast]} 3 Configure soft-configuration for the neighbors belonging to the template. soft-reconfiguration inbound 4 Clear all information or only specific details in EXEC mode. clear ip bgp {neighbor-address | * } [soft in] • * - Clears all peers. • neighbor-address - Clears the neighbor with this IP address. Soft-reconfiguration of IPv4 neighbor OS10(conf-router-neighbor)# address-family ipv4 unicast OS10(conf-router-bgp-neighbor-af)# soft-reconfiguration inbound Soft-reconfiguration of IPv6 neighbor OS10(conf-router-neighbor)# address-family ipv6 unicast OS10(conf-router-bgp-neighbor-af)# soft-reconfiguration inbound BGP commands activate Enables the neighbor or peer group to be the current address-family identifier (AFI). Syntax activate Parameters None Default Not configured Command Mode ROUTER-BGP-NEIGHBOR-AF Usage Information This command is used for exchanging IPv4 or IPv6 address family information with IPv4 or IPv6 neighbor. IPv4 unicast Address family is enabled by default. To activate IPv6 address family for IPv6 neighbor, use the activate command. To de-activate IPv4 address family for IPv6 neighbor, use the no activate command. Example OS10(conf-router-neighbor)# address-family ipv4 unicast OS10(conf-router-bgp-neighbor-af)# activate Supported Releases 10.2.0E or later add-path Allows the system to advertise multiple paths for the same destination without replacing previous paths with new ones. Syntax Parameters add-path {both path count | receive | send path count} • both path count - Enter the number of paths to advertise to the peer, from 2 to 64. 298 Layer 3