Dell MX5108n OS10 Enterprise Edition User Guide for PowerEdge MX IO Modules Re - Page 189

2 Enter the multiplier value for the hold time in CONFIGURATION mode. lldp holdtime-multiplier 3 Enter the delay (in seconds) for LLDP initialization on any interface in CONFIGURATION mode. lldp reinit Configure LLDPDU timer OS10(config)# lldp timer 60 OS10(config)# do show lldp timers LLDP Timers: Holdtime in seconds: 120 Reinit-time in seconds: 2 Transmit interval in seconds: 60 Configure LLDPDU intervals OS10(config)# lldp holdtime-multiplier 2 OS10(config)# do show lldp timers LLDP Timers: Holdtime in seconds: 60 Reinit-time in seconds: 2 Transmit interval in seconds: 30 Disable and re-enable LLDP By default, LLDP is enabled for each interface and globally. You can disable LLDP on an interface or globally. If you disable LLDP globally, LLDP is disabled on all interfaces irrespective of whether LLDP is previously enabled or disabled on an interface. When you enable LLDP globally, the LLDP configuration at the interface level takes precedence over the global LLDP configuration. 1 Disable the LLDPDU transmit or receive in INTERFACE mode. no lldp transmit no lldp receive 2 Disable the LLDP holdtime multiplier value in CONFIGURATION mode. no lldp holdtime-multiplier 3 Disable the LLDP initialization in CONFIGURATION mode. no lldp reinit 4 Disable the LLDP MED in CONFIGURATION or INTERFACE mode. no lldp med 5 Disable LLDP TLV in INTERFACE mode. no lldp tlv-select 6 Disable LLDP globally in CONFIGURATION mode. no lldp enable Disable LLDP OS10(config)# no lldp timer 100 OS10(config)# no lldp holdtime-multiplier 10 OS10(config)# no lldp reinit 8 Disable LLDP interface OS10(config)# interface ethernet 1/1/4 OS10(conf-if-eth1/1/4)# no lldp med OS10(conf-if-eth1/1/4)# no lldp tlv-select OS10(conf-if-eth1/1/4)# no lldp transmit OS10(conf-if-eth1/1/4)# no lldp receive Layer 2 189