Dell MX5108n OS10 Enterprise Edition User Guide for PowerEdge MX IO Modules Re - Page 158

Example OS10(config)# interface vlan 1023 10OS10(conf-if-vl-1023)# exit OS10(config)# vfabric 100 OS10(conf-vfabric-100)# vlan 1023 Supported Releases 10.3.1E or later zone default-zone permit Enables access between all logged-in FC nodes of vfabric in the absence of an active zoneset configuration. A default zone advertises a maximum of 527 members in the registered state change notification (RSCN) message. Syntax zone default-zone permit Parameters None Defaults Not configured Command Mode Vfabric CONFIGURATION Usage Information The no version of this command disables access between FC nodes in the absence of an active zoneset. Example OS10(config)# vfabric 100 OS10(conf-vfabric-100)# zone default-zone permit Supported Releases 10.3.1E or later zoneset activate Activates an existing zoneset. You can activate only one zoneset in a vfabric. Syntax zoneset activate zoneset-name Parameters zoneset-name - Enter an existing zoneset name. Defaults Not configured Command Mode Vfabric CONFIGURATION Usage Information The no version of this command deactivates the zoneset. After you disable an active zoneset, the zone default-zone permit command configuration takes effect. Based on this configuration, the default zone allows or denies access between all the logged-in FC nodes of the vfabric. Example OS10(config)# vfabric 100 OS10(conf-vfabric-100)# zoneset activate set Supported Releases 10.3.1E or later 158 Fibre channel