Dell MX5108n OS10 Enterprise Edition User Guide for PowerEdge MX IO Modules Re - Page 466

ntp trusted-key Sets a key to authenticate the system to which NTP synchronizes with. Syntax Parameters Default Command Mode Usage Information Example ntp trusted-key number number - Enter the trusted key ID (1 to 4294967295). Not configured CONFIGURATION The number parameter must be the same number as the number parameter in the ntp authenticationkey command. If you change the ntp authentication-key command, you must also change this command. The no version of this command removes the key. OS10(config)# ntp trusted-key 234567 Supported Releases 10.2.0E or later show ntp associations Displays the NTP master and peers. Syntax Parameters Default Command Mode Usage Information show ntp associations [vrf management] None Not configured EXEC • (none) - One or more of the following symbols displays: - * - Synchronized to this peer. - # - Almost synchronized to this peer. - + - Peer was selected for possible synchronization. - - - Peer is a candidate for selection. - ~ - Peer is statically configured. • remote - Remote IP address of the NTP peer. • ref clock - IP address of the remote peer's reference clock. • st - Peer stratum (number of hops away from the external time source). 16 means that the NTP peer cannot reach the time source. • when - Last time the device received an NTP packet. • poll - Polling interval (in seconds). • reach - Reachability to the peer (in octal bitstream). • delay - Time interval or delay for a packet to complete a round-trip to the NTP time source (in milliseconds). • offset - Relative time of the NTP peer's clock to the network device clock (in milliseconds). • disp - Dispersion. Example OS10# show ntp associations remote ref clock st when poll reach delay offset disp 10.10.120.5 0.0.0.0 16 - 256 0 0.00 0.000 16000.0 466 System management