Dell MX5108n OS10 Enterprise Edition User Guide for PowerEdge MX IO Modules Re - Page 407

ipv6 ospf passive Configures an interface as a passive interface and suppresses routing updates (both receiving and sending) to the passive interface. Syntax ipv6 ospf passive Parameters None Default Not configured Command Mode INTERFACE Usage Information You must configure the interface before setting the interface to passive mode. The no version of the this command disables the Passive interface configuration. Example OS10(config)# interface ethernet 1/1/6 OS10(conf-if-eth1/1/6)# ipv6 ospf passive Supported Releases 10.3.0E or later ipv6 ospf priority Sets the priority of the interface to determine the designated router for the OSPFv3 network. Syntax ipv6 ospf priority number Parameters number - Enter a router priority number (0 to 255). Default 1 Command Mode INTERFACE Usage Information When two routers attached to a network attempt to become the designated router, the one with the higher router priority takes precedence. The no version of this command resets the value to the default. Example OS10(config)# interface ethernet 1/1/6 OS10(conf-if-eth1/1/6)# ipv6 ospf priority 4 Supported Releases 10.3.0E or later log-adjacency-changes Enables logging of syslog messages about changes in the OSPFv3 adjacency state. Syntax Parameters Default Command Mode Usage Information Example log-adjacency-changes None Disabled ROUTER-OSPFv3 The no version of this command resets the value to the default. OS10(config)# router ospfv3 100 OS10(config-router-ospfv3-100)# log-adjacency-changes Supported Releases 10.3.0E or later Layer 3 407