Dell MX5108n OS10 Enterprise Edition User Guide for PowerEdge MX IO Modules Re - Page 459

• address - Enter an IPv4 or IPv6 address of the name server in A.B.C.D or A::B format. Default Command Mode Usage Information Example Not configured CONFIGURATION The name-to-IP address table uses this mapping information to resolve host names. The no version of this command disables the mapping. OS10(config)# ip host dell 1.1.1.1 Supported Releases 10.2.0E or later ip name-server Configures up to a three IPv4 or IPv6 addresses used for network name servers. Syntax Parameters ip name-server ip-address [ip-address2 ip-address3] • ip-address - Enter the IPv4 or IPv6 address of a domain name server to use for completing unqualified names (incomplete domain names that cannot be resolved). • ip-address2 ip-address3 - (Optional) Enter up two additional IPv4 or IPv6 name servers, separated with a space. Default Command Mode Usage Information Example Not configured CONFIGURATION OS10 does not support sending DNS queries over a VLAN. DNS queries are sent out on all other interfaces, including the Management port. You can separately configure both IPv4 and IPv6 domain name servers. In a dual stack setup, the system sends both A (request for IPv4) and AAAA (request for IPv6) record requests to a DNS server even if you only configure this command. The no version of this command removes the IP name-server configuration. OS10(config)# ip name-server 10.1.1.5 Supported Releases 10.2.0E or later show hosts Displays the host table and DNS configuration. Syntax Parameters Default Command Mode Usage Information Example show hosts None Not configured EXEC This command displays domain and host information. OS10# show hosts Default Domain Name : dell.com Domain List : abc.com Name Servers : 1.1.1.1 20::2 Static Host to IP mapping Table System management 459