Dell MX5108n OS10 Enterprise Edition User Guide for PowerEdge MX IO Modules Re - Page 376

Default Command Mode Usage Information Example Not configured INTERFACE When neighbors exchange DBD packets, the OSPF process checks if the neighbors are using the same MTU on a common interface. If the receiving MTU in the DBD packet is higher than the IP MTU configured on the incoming interface, OSPF adjacency does not establish. The no version of this command disables the IP OSPF mtu-ignore configuration. OS10(conf-if-vl-10)# ip ospf mtu-ignore Supported Releases 10.2.0E or later ip ospf network Sets the network type for the interface. Syntax ip ospf network {point-to-point | broadcast} Parameters • point-to-point - Sets the interface as part of a point-to-point network. • broadcast - Sets the interface as part of a broadcast network. Default Command Mode Usage Information Example Broadcast INTERFACE The no version of this command resets the value to the default. OS10(conf-if-eth1/1/1)# ip ospf network broadcast Supported Releases 10.2.0E or later ip ospf passive Configures an interface as a passive interface and suppresses routing updates (both receiving and sending) to the passive interface. Syntax Parameters Default Command Mode Usage Information Example ip ospf passive None Not configured INTERFACE You must configure the interface before setting the interface to Passive mode. The no version of the this command disables the passive interface configuration. OS10(conf-if-eth1/1/6)# ip ospf passive Supported Releases 10.2.0E or later ip ospf priority Sets the priority of the interface to determine the designated router for the OSPF network. Syntax ip ospf priority number Parameters number - Enter a router priority number (0 to 255). Default 1 376 Layer 3