HP Visualize J5000 hp Visualize J5000, J7000 workstations owner's guide (a4476 - Page 138
Installing, Removable, Media Devices
View all HP Visualize J5000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 138 highlights
Installing Removable Media Devices Your workstation can have any two of the following removable media devices, with no two the same: • CD-ROM drive • 2 to 8 GB, 4 mm DDS tape drive • 3.5-inch Floppy disk drive Follow these steps for installing any of the removable media drives into the Storage Assembly. The steps for checking and setting drive jumpers are different for each drive. Jumper information for each drive is included in these steps. NOTICE: Before opening the system unit, follow the instructions in "Checking the SCSI IDs," earlier in this appendix, to determine the SCSI IDs currently in use on your workstation. 1. Open the system unit according to the directions in "Opening the System Unit," earlier in this appendix. 2. Unscrew the two captive screws on the left side of the Storage Assembly and pull down the drawer ejector handle on the right side of the Storage Assembly, as shown in Figure A-3. The Storage Assembly slides partway out of the drawer. B-10