HP Visualize J5000 hp Visualize J5000, J7000 workstations owner's guide (a4476 - Page 210

4. If you are using HP-UX 9.05, you can determine which SCSI IDs are currently in use by looking under the H/W Path heading. The listing 2.0.1 scsi is the built-in SCSI bus controller. For devices connected to the built-in SCSI bus, such as disks, the fourth number is the SCSI ID for that device. For example, the listing 2.0.1.6.0 in the sample device list tells you that there is a SCSI device (a disk) currently using ID 6 on the SCSI bus. The information is presented in a different format if you are using HP-UX 10.0, although you still look under the H/W Path heading. Single-Ended Standard System SCSI Device IDs Before assigning a SCSI device ID to your drive, you need to check your SCSI device IDs. To check what SCSI device IDs are available and assign an ID to your device, follow these instructions which use Table C-7: 1. Write in the SCSI device ID of any internal drives in Table C-7. 2. Write in the type of external drives (single-ended standard, EISA, or fast, wide devices) currently connected to your system under the heading "External Device Drives" and each drive's SCSI device ID under the heading "Device ID Number." 3. Add your new drive to the table if it is an external device. If it is an internal drive, continue to Step 4. NOTICE: The C1700A Magneto-Optical Autochanger uses three SCSI addresses, and accounts for three of the seven devices allowed on the SCSI bus. C-16