HP Visualize J5000 hp Visualize J5000, J7000 workstations owner's guide (a4476 - Page 148
Floppy Drive
View all HP Visualize J5000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 148 highlights
Floppy Drive The floppy disk drive ships with the drive set to SCSI ID address 0. We recommend keeping the address setting at 0 unless it is used by another device. CAUTION: Floppy disk drives are susceptible to mechanical and electrostatic shock. When handling the drive, always wear the static-grounding wrist strap that came in the floppy disk drive kit. Always handle the drive carefully. If you need to change the floppy disk drive's address, follow these instructions, referring to Figures A-10 and A-11. If you do not need to change the drive's address, go to Step 10 of this installation procedure. 1. Locate the jumpers on the top of the floppy drive. 2. To change the jumpers, use needlenose pliers to set the drive's SCSI ID to an address that is not used by another SCSI device. Check that the other jumpers are set correctly. NOTICE: Do not use SCSI ID 7 for your floppy drive's SCSI address. The host SCSI controller uses SCSI ID 7. 3. Use needlenose pliers to remove the SCSI terminators, if still attached to the drive. B-20